I had this problem recently and phoned A and H for advice. The gentleman recommended leaving the Lenz unit (LZV100 in my case) plugged in for 4 to 5 hrs to give the internal battery a good charge. This certainly worked for me so perhaps worth a try before doing anything else.
Update - took out capacitors and changed motors (was doing that anyway) and no difference. Played with CVs and changing CV4 to 2 was the only one that allowed the locos to stop. Any other setting didn't work.
Yes both directions.
They sometimes stop.
Fine in other locos.
I don't have access to DC.
No problems set at zero.
Keep going if lifted then replaced.
Also sometimes ignore emergency stop but eventually do.
Help. I have 2 locos that wont stop once set in motion, in either direction. At first I thought it was maybe the decoders (both Zimo. 1 MX622 & 1 MX621) so changed them to Lenz silver minis but no different. Any suggestions please people?
Cheers
Right I've been through the entire thread and can't see any reference to this so here goes. Does this take 6 pin or Next 18 ? (Apologies if it is out there and I've missed it)
Cheers