cb900f

Managed to find them. Regards Pete

Pete, I think I still have that drawing. I will find it out and send it unless someone else also obliges. Regards Pete

As my mum told me "never make your hobby your job" Pete

The coking plant near Rotherham may well have been "Manvers" which is just North of Swinton on the Midland main line from Cudworth. Long gone of course , now a nature reserve i believe.

Yes it does work . Sainsburys £3.50.

Nick, I have been in contact with Iain with regards to the same subject and even asked him the same question. He obligingly replied with the answer page 2911 Regards Pete

Alan Gibson, 2 different lengths 1.2 mm and 1.7mm . £4.70 for 25

Without wanting to dwell on the subject , here are 2 photos of my old trainspotting days in the early to middle 60s and recently. For information it is Clay Cross South Jct. Lines to the left go down the Erewash Valley ( Toton, Nottingham and Trent ) lines to the right go to Derby. They are not my photos and therefore I do not know who has the copyrights, if necessary please delete

Tony, If I remember correctly Mousa Models do a number of 04 variants. Pete

Superb modelling Iain but the comment with regards to 30 degrees was below the belt at this present time in the uk. Regards Pete

Horns Bridge, which is approx 1/4 -1/2 mile south of Chesterfield Station.

Just a general question with regards to 3d printing. No doubt it depends on the plastic used in the process, but how resilient/brittle is the plastic in the finished model ? I'm sure Tony built a 3D loco some time back and parts broke off before he had basically started ? Pete

Clay Cross never had flashing yellows although I agree it was a perfect example of a situation that should have. If you remember they relocated the signal to the north side of the station bridge thereby giving the Dvr an earlier view of the aspect displayed.

Tony, The short circuit has been sorted. one of the brake shoes was too close to the wheel tread. No doubt due to a Royal Mail rough shunt as a rear guard iron had come adrift too and was laying loose in the box. No problem, just a quick in and out with the soldering iron. Still well pleased with my purchase. Regards Pete

..