-
Posts
961 -
Joined
-
Last visited
Tricky-CRS's Achievements
743
Reputation
Bookmarks
-
A Venture Into The Unknown - Elegoo Mars 3D Resin Printer
A Venture Into The Unknown - Elegoo Mars 3D Resin PrinterResin Test Piece Results.
I'm honestly blown away by this little machine. I half expected this to be at best a partial failure, mainly down to the minimum 0.4mm material thickness.
The file took a lot less than the 12 mins it said to print, during the print the characteristic pop as the build plate peels the cured layer off the FEP could not be heard and i'd resigned myself to it being stuck to the FEP.
How wrong i was !
Length: 40mm
Width: 20mm
Min Thickness: 0.4mm
Max Thickness 1.5 mm
Cost: £0.03
Electricity £0.02 (no cups of coffee).
I can't really discuss the test results as the item has not fully cured. Certainly it looks helpful for determining seperation between detail, widths and depths of detail.
I measured the actual length and width as shrinkage is reported at 7% . Uncured it is on the money in both measurements.
Mark
PS I've included the .OBJ file should anyone wish to use it