RSS Fetcher Posted January 27, 2019 Share Posted January 27, 2019 I cut my DCC teeth using Digitrax. Much of the basic kit was bought on various trips to the USA. I like the system with its two control nobs on each handset and 5amps which allows power to spare for the sound decoders I wanted. I use a DS100 with a DB150 as a booster I was an early purchaser of Cobalt point motors and found a few troublesome. But DCC Concepts have been very supportive. Their latest Cobalt IP is great and saves the wiring involved with separate stationery decoders. The photo shows the Digitrax 64s I use for the older Cobalts. The aim is to move all the control equipment off the baseboards. I have recently bought a couple of Cobalt SS surface mounting point motors and they also seem very good. I did consider the MERG route and although I admire their work I do not think I am quite up to grasping the intricacies! Attached thumbnail(s) View the full article Link to post Share on other sites More sharing options...
Recommended Posts