Jump to content
 

Blog- Broadtemple - Electrics


RSS Fetcher
 Share

Recommended Posts

I cut my DCC teeth using Digitrax. Much of the basic kit was bought on various trips to the USA. I like the system with its two control nobs on each handset and 5amps which allows power to spare for the sound decoders I wanted. I use a DS100 with a DB150 as a booster
I was an early purchaser of Cobalt point motors and found a few troublesome. But DCC Concepts have been very supportive. Their latest Cobalt IP is great and saves the wiring involved with separate stationery decoders. The photo shows the Digitrax 64s I use for the older Cobalts.

The aim is to move all the control equipment off the baseboards.

 

I have recently bought a couple of Cobalt SS surface mounting point motors and they also seem very good.
I did consider the MERG route and although I admire their work I do not think I am quite up to grasping the intricacies!

Attached thumbnail(s)
  • blogentry-4181-0-44285800-1548605889_thu


View the full article
Link to post
Share on other sites

 Share

×
×
  • Create New...