mason Posted March 28, 2019 Share Posted March 28, 2019 Hi I’m after some advice if possible. I’m running an ECoS 50210 unit on a layout that has 46 digital cobalt motors, these are wired into the dcc bus and have programmed well. However I have 11 motors that will run perfectly and then they lose there address. They programme in again fine and run for a while but lose there address again, always the same 11. Iv sent the motors back to dcc Concepts and there fine and Iv fitted a brand new batch of 11 but after a while they do the same. Can anyone help?? Link to post Share on other sites More sharing options...
RMweb Gold Phil Bullock Posted March 28, 2019 RMweb Gold Share Posted March 28, 2019 Are they all on the same part of the Bus? Phil Link to post Share on other sites More sharing options...
RMweb Gold PaulRhB Posted March 28, 2019 RMweb Gold Share Posted March 28, 2019 (edited) It's most likely a spike as you get a short, there are a couple of topics covering it and the best advice is to fit a snubber, suppressor or terminator, depending on the maker across the end of the bus See details here DCC Concepts own one here https://www.dccconcepts.com/product/bus-suppressorsterminators-2-pack/ Edited March 28, 2019 by PaulRhB Link to post Share on other sites More sharing options...
mason Posted March 28, 2019 Author Share Posted March 28, 2019 Yes there all on the same bus ill look into the snubber and see what it’s all about Link to post Share on other sites More sharing options...
RMweb Gold PaulRhB Posted March 28, 2019 RMweb Gold Share Posted March 28, 2019 DCC Concepts own one here https://www.dccconcepts.com/product/bus-suppressorsterminators-2-pack/ Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now