Jump to content

Recommended Posts

I've tried different ways to try an achieve a compounded roof end but have had no luck. If anyone out there can draw my carriage end in Cubify so that I can then look into the file step by step it would be great. I don't have the funds to purchase another program so I need someone to show the file in Cubify. Pictures below of what I need.  There are two styles of roofs.  I hope to 3D print a  master and then vacuum form the roofs in 0.5mm styrene. Thanks in advance - Chris

CE roof.png

bpl099.jpg

Share this post


Link to post
Share on other sites

Ooops did write a reply but It didn't post.. any way will post again. This looks like it should be a draw both side and end profile.  Loft them and interct the lofts..  will draw diagrams when back at work :)

  • Like 1

Share this post


Link to post
Share on other sites
On 23/05/2019 at 21:47, calvin Streeting said:

Ooops did write a reply but It didn't post.. any way will post again. This looks like it should be a draw both side and end profile.  Loft them and interct the lofts..  will draw diagrams when back at work :)

Calvin did the plan I sent via email help at all. Cheers Chris

Share this post


Link to post
Share on other sites
2 hours ago, Spiritofprogress said:

Calvin did the plan I sent via email help at all. Cheers Chris

could not see them in my email :( ... was that calvin(at)absentdream(dot)com :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.