Spiritofprogress Posted May 17, 2019 Share Posted May 17, 2019 I've tried different ways to try an achieve a compounded roof end but have had no luck. If anyone out there can draw my carriage end in Cubify so that I can then look into the file step by step it would be great. I don't have the funds to purchase another program so I need someone to show the file in Cubify. Pictures below of what I need. There are two styles of roofs. I hope to 3D print a master and then vacuum form the roofs in 0.5mm styrene. Thanks in advance - Chris Link to post Share on other sites More sharing options...
Spiritofprogress Posted May 23, 2019 Author Share Posted May 23, 2019 Ok, no cubify replies. Can someone show me how to do it in Sketchup and I'll learn it instead as Cubify seems to have died Link to post Share on other sites More sharing options...
calvin Streeting Posted May 23, 2019 Share Posted May 23, 2019 Ooops did write a reply but It didn't post.. any way will post again. This looks like it should be a draw both side and end profile. Loft them and interct the lofts.. will draw diagrams when back at work 1 Link to post Share on other sites More sharing options...
Spiritofprogress Posted June 3, 2019 Author Share Posted June 3, 2019 On 23/05/2019 at 21:47, calvin Streeting said: Ooops did write a reply but It didn't post.. any way will post again. This looks like it should be a draw both side and end profile. Loft them and interct the lofts.. will draw diagrams when back at work Calvin did the plan I sent via email help at all. Cheers Chris Link to post Share on other sites More sharing options...
calvin Streeting Posted June 3, 2019 Share Posted June 3, 2019 i will look Link to post Share on other sites More sharing options...
calvin Streeting Posted June 3, 2019 Share Posted June 3, 2019 2 hours ago, Spiritofprogress said: Calvin did the plan I sent via email help at all. Cheers Chris could not see them in my email ... was that calvin(at)absentdream(dot)com Link to post Share on other sites More sharing options...
Spiritofprogress Posted June 5, 2019 Author Share Posted June 5, 2019 Sent files today. Found out as I replied to your post they went to into@RMWEB! Silly me. Cheers Chris Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now