Black5 Posted October 4, 2019 Share Posted October 4, 2019 Evening all, I have a loco with a Zimo MX600R decoder in it that has suddenly decided to run at one speed only. Prior to this it had been fine but now wont respond to the controller. It`s also not responding to the emergency stop. Having never come across this before I wondered if anyone might know the reason why. I have another similar decoder but I`m reluctant to try it in case I end up damaging that one. Many thanks, Jim. Link to post Share on other sites More sharing options...
WIMorrison Posted October 5, 2019 Share Posted October 5, 2019 Have you tried the Zimo Hard Reset described elsewhere? Might help Link to post Share on other sites More sharing options...
Pete the Elaner Posted October 5, 2019 Share Posted October 5, 2019 46 minutes ago, WIMorrison said: Have you tried the Zimo Hard Reset described elsewhere? Might help I previously made a note of that to stop me from having to search for it again. Change CVs in the following order: CV7 0 CV31 0 CV32 0 CV8 8 CV15 0 CV16 0 CV8 8 CV144 0 Link to post Share on other sites More sharing options...
Black5 Posted October 5, 2019 Author Share Posted October 5, 2019 Thanks for your reply. No I haven`t tried that. I`m going to have another look later to see if there`s anything else going on that I haven`t spotted. Link to post Share on other sites More sharing options...
Black5 Posted October 5, 2019 Author Share Posted October 5, 2019 Thanks Pete the Elaner, I`ll note those down as well. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now