RMweb Gold Corbs Posted November 16, 2019 RMweb Gold Share Posted November 16, 2019 Heya I've ballsed up a bit, in that I've accidentally paired 2 locos to the same notch on the Tx-22 selecta. How can I pair the loco to a different notch? I've tried to do the thing where you turn them both off, start the Tx in bind mode on another notch, and then turn the Rx on, but nothing happens. Pls help kthx Link to post Share on other sites More sharing options...
idd15 Posted November 16, 2019 Share Posted November 16, 2019 You will need to put the RX in bind mode first, then turn on the Tx in bind mode. Looking at the DT site it suggests turning on the Rx first and leaving it for 20 secs, then it should go automatically into bind mode. When binding it also best not to have the Tx too close as this can swamp the Rx and hinder the bind process. This may not be a problem for DT gear but the original Spektrum DSM2 receivers were prone to this. HTH idd 1 Link to post Share on other sites More sharing options...
RMweb Gold Corbs Posted November 16, 2019 Author RMweb Gold Share Posted November 16, 2019 Woo! That was it, thanks so much. Link to post Share on other sites More sharing options...
idd15 Posted November 17, 2019 Share Posted November 17, 2019 Timing is everything! Glad it’s sorted for you. idd Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now