MattC Posted January 13, 2020 Share Posted January 13, 2020 Hi All I am new to this so bear with me. I have a faller car system in place but need to control the faller junction turnout device and the faller bus stop reed switch activation. I tried a Hornby controller which claimed to have a 16v ac output but it did nothing. Do I have to bite the bullet and buy the expensive for what it is Faller one? Any guidance most welcome. Matt 1 Link to post Share on other sites More sharing options...
Mike Harvey Posted January 13, 2020 Share Posted January 13, 2020 (edited) Faller 161675 Stop Solenoid should be connected to 12-22 volts dc according to the instructions. I believe they are current hungry. The branch off junction needs 12-16 volts AC or DC continuously on when set to diverge. The solenoid only holds the wire to diverge whilst powered. There is a Facebook group for Faller Car System with most of the instruction leaflets in English Edited January 13, 2020 by Mike Harvey Added info 1 Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now