Dapol Class 22 CV settings advice

[MikeJT]

Hi all,

 

I've just fitted a DCC Concepts Zen decoder to my Dapol Class 22 and would appreciate some guidance on CV setting as I'm still new to this sort of thing.

 

I use a NCE Power cab and successfully changed CV's 33,34,35,36 as detailed in the enclosed leaflet.

This was partially successful as far as the lighting functions were concerned.

F0, F1 and F2 then work as the leaflet describes - I'm unable to get the cab lights to work though.

Reading the leaflet I think this is what Dapol are describing when (as is the case with the Power cab) F2 is just a momentary switch.

 

I'm getting a bit lost at that point...

 

Can anyone advise what values I need to set in CV's 33,34,35,36 as I don't fully understand the table Dapol provide?

 

Thanks.

 

Mike