regme Posted May 15, 2020 Share Posted May 15, 2020 Hi I'm printing this wagon and I'm getting the bump. It look's like the ridge line is being pushed outwards, it occurrs very20mm. I'm printing it on an Anycubic Photon and the model is printed vertically on a 10 degree slope. I spoke to Anycubic and they send a replacement for the z-motor, but I'm still getting this ridge. If anyone has any ideas that would be appreciated Cheers Link to post Share on other sites More sharing options...
RMweb Premium njee20 Posted May 15, 2020 RMweb Premium Share Posted May 15, 2020 Did they send a replacement motor, or the threaded rod? I'd suggest the threaded rod was slightly bent. A few layers are misaligned every 20mm. Link to post Share on other sites More sharing options...
regme Posted May 15, 2020 Author Share Posted May 15, 2020 They sent both Link to post Share on other sites More sharing options...
RMweb Premium TheQ Posted May 15, 2020 RMweb Premium Share Posted May 15, 2020 I think this could take 9 months to solve... 1 Link to post Share on other sites More sharing options...
regme Posted May 15, 2020 Author Share Posted May 15, 2020 Gold, you missed your calling, you should be in stand up Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now