Jump to content

Recommended Posts



I'm printing this wagon and I'm getting the bump.  It look's like the ridge line is being pushed outwards, it occurrs very20mm.


I'm printing it on an Anycubic Photon and the model is printed vertically on a 10 degree slope.


I spoke to Anycubic and they send a replacement for the z-motor, but I'm still getting this ridge.  If anyone has any ideas that would be appreciated




Link to post
Share on other sites

Did they send a replacement motor, or the threaded rod? I'd suggest the threaded rod was slightly bent. A few layers are misaligned every 20mm.

Link to post
Share on other sites

I think this could take 9 months to solve... 

  • Funny 1
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.