phil gollin Posted May 25, 2020 Share Posted May 25, 2020 . Which readily available contemporary track is suitable to run the coarse scale Tri-ang locos and rolling stock on ? (I know that Series 4 track is readily available secondhand, but I;d like something a bit better) Thanks. . 1 Link to post Share on other sites More sharing options...
stewartingram Posted May 25, 2020 Share Posted May 25, 2020 I've got loco chassis from the Triang era - coarse - that run on my Peco code 75, with just minor tweaking to b2b settings. Previously the code 100 was fine. Stewart Link to post Share on other sites More sharing options...
Paul H Vigor Posted May 25, 2020 Share Posted May 25, 2020 26 minutes ago, phil gollin said: . Which readily available contemporary track is suitable to run the coarse scale Tri-ang locos and rolling stock on ? (I know that Series 4 track is readily available secondhand, but I;d like something a bit better) Thanks. . I have found that vintage locos and rolling stock with very deep wheel flanges are inclined to strike every chair when running on modern commercial track. Link to post Share on other sites More sharing options...
RMweb Premium rab Posted May 25, 2020 RMweb Premium Share Posted May 25, 2020 3 hours ago, Paul H Vigor said: I have found that vintage locos and rolling stock with very deep wheel flanges are inclined to strike every chair when running on modern commercial track. You could always try filing flats on the flanges to clear the chairs 1 Link to post Share on other sites More sharing options...
stewartingram Posted May 25, 2020 Share Posted May 25, 2020 4 hours ago, Paul H Vigor said: I have found that vintage locos and rolling stock with very deep wheel flanges are inclined to strike every chair when running on modern commercial track. Only problem I have with the code 75 & flanges hitting chairs, is with the Lima wheels. I'm gradually going through my stock and turning them down on the lathe (just a few dmus). I don't get the Triang ones striking the chairs. Stewart ps I did notice a problem yesterday, I got a loco out of my roundtuit box. Basically a standard Triang chassis (with a resin replacement body) and a standard Triang B12 tender. The loco needed a clean/service, then ran fine on the code 75. However the tender had a problem with its wheels. They were the plastic "1/2 axle" type on a steel axle, so the b2b can vary. I had to superglue them apart a bit wider to get a near enough correct b2b; this is temporary as I shall be replacing them with metal ones. Before sticking them to the axles, they really wobbled through the points as the b2b was far too narrow. 1 Link to post Share on other sites More sharing options...
Devo63 Posted May 28, 2020 Share Posted May 28, 2020 Most of my old Triang locos and rolling stock run quite well on Peco code 100. Some of the very oldest such as a late 50's Princess do make a bit of noise and occasionally derail the front bogie going through modern points but on the whole are fairly reliable. Dave R. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now