nigelwright7557 Posted November 23, 2020 Share Posted November 23, 2020 I have managed to build my own DCC controller. The software currently can move a train forward and reverse at a speed I set. So far so good. My next step is to start programming CV's. I have looked high and low and cant find the data packet information. Lots of info around on which CV does what but very little on data format to be sent to the loco. Any help would be appreciated. Link to post Share on other sites More sharing options...
WIMorrison Posted November 23, 2020 Share Posted November 23, 2020 Have you looked in the NMRA standards? I am sure that this is all defined within them Link to post Share on other sites More sharing options...
nigelwright7557 Posted November 23, 2020 Author Share Posted November 23, 2020 Thanks for the standards name. I found the data I am looking for in there. Link to post Share on other sites More sharing options...
nigelwright7557 Posted December 3, 2020 Author Share Posted December 3, 2020 Managed to get my system to change CV1 now. It takes quite a few loops code but works fine now. Thanks for the help. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now