PRE-MADE CROSS BOARD JOINS???

[exmoordave]

Hi everyone,

I'm just hoping that someone can help me track down a new product - and which I should have written details of at the time? !! It was made by a small concern I'm sure and consisted of a pair of cross-board joining plates to which tracks could be soldered and feeds attached. The most distinguishing feature was that the sides to be joined had a wavey edge on each side, so hopefully allowing excellent alignment every time when using cassettes for example. 

If anyone can remember the name of the company/product I would be very grateful. It would also be great, to hear if anyone has actually used them for cassettes please.

Many thanks in advance & best to all

exmoordave

[Tony Cane]

The company is Modeltech, web site is the same name.

[Gilbert]

I've used their Peco Code 75 (not Bullhead) for base board joints and they seem good. I was keen they did HO C83 and they now seem to be on the way.

 

[exmoordave]

Evening gents. I've just seen your replies and wanted to say many thanks for your help, it is much appreciated. They look to be something I could use with the new Peco bullhead track on my new layout. 

Thanks again and stay safe,

Best wishes

exmoordave

[Gilbert]

14 minutes ago, exmoordave said:

Evening gents. I've just seen your replies and wanted to say many thanks for your help, it is much appreciated. They look to be something I could use with the new Peco bullhead track on my new layout. 

Thanks again and stay safe,

Best wishes

exmoordave

Glad to help Dave

So far I've been very pleased - you'll note I added some 3mm ply inset into the 3mm cork so alignment was easier to achieve.

Best

Chris