tark61 Posted December 14, 2020 Share Posted December 14, 2020 Hi trying to fit a chip to the power car of the new Bachmann 414 instruction points to clip, note 2 extra extra screws cab end, but unable to remove clips at non dring end of car, so managed to fit a chip but when i tried replacing body found this was near imposible cab wnd will not sit leaving a 1mm gap between boody and chassis, need help am i missing something Regards Link to post Share on other sites More sharing options...
SRman Posted December 14, 2020 Share Posted December 14, 2020 I don't remember removing any screws. They may be the ones holding the cab moulding in place. They are fiddly to remove the bodies, and even more fiddly to replace, but mine did eventually clip back in. I found I had to jiggle it a little to get it to sit over the cab lighting properly, then lowered the body as evenly as possible onto the chassis, before easing the sides slightly at one end to get it it sit down, then the same thing at the other end before firmly pushing the whole length of the body down. Link to post Share on other sites More sharing options...
RMweb Gold Roy Langridge Posted December 15, 2020 RMweb Gold Share Posted December 15, 2020 (edited) Haven't done my HAP yet, but I am pretty sure that on the other Bachmann EMUs you have to put the cab end in first when refitting the body, then the inner end. Roy Edited December 15, 2020 by Roy Langridge 1 Link to post Share on other sites More sharing options...
andyman7 Posted December 17, 2020 Share Posted December 17, 2020 I do wish it was easier to install the DCC decoders on these Southern EMU models, the Desiro/Class 90 approach of a removable panel is much more user friendly 1 Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now