Jump to content
 

Dimming headlights on Loksound v5


LNERGE
 Share

Recommended Posts

Lets assume that the wiring was done done in the usual way which means front lights are connected to 'front light' output and rear lights are connected to 'rear light' output.

 

To change brightness you first have to tell the decoder that you want to change something on the output settings

by writing    (before doing anything else !!!)

CV 31 = 16, CV 32 = 0.

 

Then read CV 262 and CV 270 as these are the brightness values for front and rear light.

Maximum value is 31 so decrease these values according to your needs and rewrite them.

Edited by Hamburger
Link to post
Share on other sites

40 minutes ago, LNERGE said:

I've read cv's 262 and 270 and both were 31. I tried 10 and then 1 but there is no change in brightness. I have read each cv back to confirm the change.

In this case it is either

- unusual wiring of the headlamps

- tricky mapping

- secondary function output setting was used ((CV31=16,CV32=0) CV422,CV430)

I find it too risky to do something seriously wrong under these circumstances. You should ask the person/shop you bought the loco from.

 

 

 

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...