Wiring up an Electrofrog 009 turnout

[Irish Padre]

Hello - I have three Peco 009 turnouts to lay. Normally a 7mm modeller, I know how to set up a switched frog. But I’m struggling here! Do I simply solder a wire to the frog and then add that to my SEEP PM1 micro switch? Is there anything else I need to do - I’m used to cutting gaps and soldering bridging wires etc but the Peco instructions are most vague! thank you in anticipation - David (ps visual aids much appreciated to bolster any explanation!) 

 

 

[WIMorrison]

I just solder to the frog

Edited May 27, 2021 by WIMorrison