franco330 Posted July 18, 2021 Share Posted July 18, 2021 Last time I used my railway I was experimenting with routes etc etc. Coming back to it after several month I seem to be unable to control switches manually. Using the normal Digitrax controller they can be controlled fine. I guess I need to get the routes to release control. I think I have deleted them successfully but ....... I probably need to reset the TC system to enable manual control somehow - but I have not been able to discover how. Could anyone give me a steer please? I wish I could find my daybook! Thanks guys Frank Link to post Share on other sites More sharing options...
jamespetts Posted July 24, 2021 Share Posted July 24, 2021 One does not need to delete route definitions to get manual control over turnouts - you should be able to control any turnout manually that is not currently being used by an active route (i.e., one that is set for a train to run on it right now) by clicking it in the switchboard window. Make sure that you are not in edit mode, however, or else you will only be able to modify the properties of the turnout, rather than switch it (easily, at least). Link to post Share on other sites More sharing options...
franco330 Posted July 25, 2021 Author Share Posted July 25, 2021 Thanks james. Up and running again. Best wishes frank Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now