Houndog1372 Posted August 12, 2021 Share Posted August 12, 2021 Hi all, I’m currently having issues with my Hornby Class 60. I’m in the process of changing over from DC, to DCC and I have recently chipped my Class 60. Removing the body-shell was a simple, however I am having issues refitting the body. No matter how hard I try, the body will just not fit properly onto the chassis. If I push one end down, the other end pops up slightly, leaving a small gap under the cabs. Does anyone have any ideas how to sort this out? I have attached some photos showing the issue in more detail. Thanks in advance! Link to post Share on other sites More sharing options...
CazRail Posted August 13, 2021 Share Posted August 13, 2021 Have you put the decoder on top of the loco's PCB? Sounds to me as if its too high not allowing the body to seat properly. I place my decders on a piece of plastic that I fit into the recesses at the 'empty' end of the chassis. This stops the decoder and harness from fouling the cardan shaft below, as well as providing an ideal place to fit your decoder loose or secured. Link to post Share on other sites More sharing options...
RMweb Premium newbryford Posted August 13, 2021 RMweb Premium Share Posted August 13, 2021 It's not usually the decoder height that's the issue, it's the way that the chassis ends/floors are fitted up inside the cabs. It is a very tight fit. I find that the chassis has to exactly dead central with the body or the floor moulding catches the body and it can take a bit of longitudinal "shuffling" of the body and chassis to make it fit One solution is to shave a very small amount (less than 0.5mm) off the plastic floor that is screwed to the chassis casting before refitting the body. 1 Link to post Share on other sites More sharing options...
Houndog1372 Posted August 14, 2021 Author Share Posted August 14, 2021 Thanks for the help everyone. I have managed to fix the loco, simply by heating the bodyshell up, and then fitting it again with a bit more persuasion. Cheers Matthew 1 Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now