siomigadjura Posted August 26, 2021 Share Posted August 26, 2021 Hello people, firstly thank you for accepting me in this forum. Secondly, running installed Rx60-22 in locos, controlled by Tx22v2. Question, is it possible to control two or more receivers (locomotives) as one, at the same time? Example, 2 locos pulling wagon composition and being controlled as one. Thank you. Link to post Share on other sites More sharing options...
RMweb Gold Corbs Posted August 26, 2021 RMweb Gold Share Posted August 26, 2021 You can pair two receivers to the same channel on the selecta, yes, but you'd need to re-pair them to undo them. Unlike DCC you can't temporarily 'consist' them together and then separate without re-pairing. Here are two locos paired to the same channel. 1 Link to post Share on other sites More sharing options...
siomigadjura Posted August 26, 2021 Author Share Posted August 26, 2021 So, its a bit of a work pairing and re pairing them , but its possibile? Or to go for a dcc way? Thanx for a video. Link to post Share on other sites More sharing options...
wasdavetheroad Posted August 28, 2021 Share Posted August 28, 2021 There is a way of getting a true consist for 2 locos with a Tx-22 but only one consist per Tx. Basically you need 2 Rx's which are factory fresh, ie not bound to your Tx or with a software reload also works. The Rx's are set to the Selecta with Tx change option. For the consist you must set both locos to Selecta position 6 as this overwrites the position used in the 'factory' for testing. Then after speed matching you set each loco to a different 2nd Selecta position. for example I have 2 Hornby 2P 4-4-0's. One bound to S4 and S6 and the other bound to S5 and S6. The locos are controlled independently with S4 and S5 and S6 controls both locos as a consist. Obviously S6 can only be used to control the consist and no other locos should be bound to it. 1 1 Link to post Share on other sites More sharing options...
siomigadjura Posted September 2, 2021 Author Share Posted September 2, 2021 Would you be kind to share how to rebind Rx60-22 from selecta 1 to selecta 2 or any other selecta by choice previously bind to Tx-22, if that's possible and not complicated. Thank you. Link to post Share on other sites More sharing options...
wasdavetheroad Posted September 2, 2021 Share Posted September 2, 2021 You just use the same procedure as the original binding of the Rx to the Tx Switch off the Tx Select the Selecta number you want to bind to Switch on the Rx, the LED flashes for about 15 seconds followed by rapid flashing Switch on the Tx whilst holding down the bind button The Rx should flash slowly a few times and then come on solid, The Rx is now bound to the new Selecta number 1 Link to post Share on other sites More sharing options...
siomigadjura Posted September 2, 2021 Author Share Posted September 2, 2021 Worked like a charm. Thank you again. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now