melvin Posted August 30, 2021 Share Posted August 30, 2021 Any one know how to remove the motor from this Loco. Can only see one screw on top that seems to retain it. Not tried to anything yet in the hope someone will know how. Regars. Mel. Link to post Share on other sites More sharing options...
AdamsRadial Posted August 30, 2021 Share Posted August 30, 2021 (edited) The screw at the back of the motor secures it to the chassis at the back, then there are lugs at the front of the motor, wiggling it gently from side to side should get them free. ETA sorry, I just realised I'm referring to the Triang L1, my advice is unlikely to be relevant to what I suspect is a Northern beast Edited August 30, 2021 by AdamsRadial 1 Link to post Share on other sites More sharing options...
RMweb Premium 31A Posted August 30, 2021 RMweb Premium Share Posted August 30, 2021 I think you need to take off the die cast block that covers the worm (at the rear end of the motor) as well; it holds down that end of the motor. I think it's held to the main part of the chassis by a screw, probably hidden beneath the wiring that runs along the top of the block. Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now