d00m Posted September 14, 2021 Share Posted September 14, 2021 I have a lot of efe '38 stock that I haven't got around to re wheeling. I have almost all the 10.5mm wheelsets I need and have about half the number of metro models bogies I need. Has anyone tried to use the original efe bogies as they are, fitting top hat Barings into them? Link to post Share on other sites More sharing options...
Lord of Narnia Posted September 19, 2021 Share Posted September 19, 2021 Yes I’ve tried. You need to drill through the axle box from the outside to get the bearings in at the correct angle. Then I’ve had to cut the bogie head stocks to bend the frame enough to get the wheel sets in! Not tried it out on the track yet but generally that is my approach. Also got some 38ts and 59/62ts bogies 3D printed and they seem to run well. 1 Link to post Share on other sites More sharing options...
d00m Posted September 20, 2021 Author Share Posted September 20, 2021 15 hours ago, Lord of Narnia said: Yes I’ve tried. You need to drill through the axle box from the outside to get the bearings in at the correct angle. Then I’ve had to cut the bogie head stocks to bend the frame enough to get the wheel sets in! Not tried it out on the track yet but generally that is my approach. Also got some 38ts and 59/62ts bogies 3D printed and they seem to run well. Thanks. I'll give it a go on a spare ndm. just need to remove the shoe gear first... Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now