Jump to content
 

Mayshill - GWR


Jules
 Share

Recommended Posts

Righto. Some more minor progress on my GW BLT.

 

I've added a water crane and fire devil (great name!), built from the Ratio kit.

 

The reddy/orange mess in the goods yard sidings is to bring the ground level almost to the top of the rails - need to obtain a 'correct' shade of grey to paint the whole yard rather than the black/dark grey that it currently is.

 

The other pics are just using up bandwidth to give some idea of whats going on! The last one shows the complete layout and fiddle yard with my rather tight cassettes.

 

post-148-039666700%201289239827_thumb.jpgpost-148-042856200%201289239831_thumb.jpgpost-148-005311400%201289239836_thumb.jpgpost-148-069396700%201289239839_thumb.jpgpost-148-065886700%201289239843_thumb.jpgpost-148-054968800%201289239848_thumb.jpgpost-148-080521300%201289239852_thumb.jpgpost-148-061469400%201289239856_thumb.jpgpost-148-011260800%201289239823_thumb.jpg

 

 

 

 

The pannier tank is an old Mainline example from about 1982 (I think) Always used to be a poor runner, stored for best part of 25 years, but now runs a treat with my KPC feedback controller.

Edited by Jules
  • Like 6
Link to post
Share on other sites

  • 2 weeks later...

I've been wondering what to do with the corner of my layout at the edge on the board in the space shown in the pic below.

post-148-094623400%201290528286_thumb.jpg

 

post-148-055454400%201290528290_thumb.jpg

 

I thought perhaps some sort of building, but I am not sure what type. Anyway, while sorting through a pile of 'stuff', I came across one of those freebie printed buildings you occasionally get in magazines - this one was from Model Trains in 1982!!!

 

So, having a spare few hours, I thought I would knock it together to see what it looked like in the space - so here it is.

 

post-148-016322000%201290528282_thumb.jpg

 

post-148-033413200%201290528294_thumb.jpg

 

post-148-000563200%201290528298_thumb.jpg

It isn't complete, but gives some idea what was intended by the magazine some 28 years ago.

 

I think it is probably a bit big for a sleepy branch line terminus, but it will fill the space for now.

 

(I should have taken a pic in its 'flat pack' mode, but forgot)

Edited by Jules
  • Like 5
Link to post
Share on other sites

Not strictly work on the layout, but work on things that run on the layout...

 

I decided that my B set was in need of some painting of the interia to improve it, so this morning I took one of the coaches apart and painted the inside. I used natural wood for the partitions and coach side, dark earth for the floor and blue/dep red for the seats.

 

I added a bit of frame dirt and roof dirt on the outside to attempt to make it look a bit more used - I think the roof needs a bit more attention!

 

Anyway, here are a couple of pics to show the out of the box coach, and the 'improved' version.

 

post-148-051008000%201290869524_thumb.jpgpost-148-070882400%201290869528_thumb.jpgpost-148-015774800%201290869533_thumb.jpgpost-148-055162500%201290869519_thumb.jpg

 

Edited by Jules
  • Like 9
Link to post
Share on other sites

Hi IKB

 

They are both Airfix coaches.

 

The unmodified one was part of a set I picked up when Airfix went bust : a BR black 61xx, the GW B coach and an LMS non-corridor coach, plus oval of track and controller for £14! (if I remember correctly).

The other one (modified) is branded as Mainline, but is from a year or two after.

Link to post
Share on other sites

  • 2 weeks later...

A bit more progress....

 

I have added a PW hut just before the bridge that forms the scenic break, as shown below.

 

It is a Wills kit, takes all of 5 minutes to make! Painted matt black with a grey roof, then the roof was weathered with black paint and the sides with 'roof grim', although it is quite subtle.

 

I have also painted the goods yard area in a shade of grey, which improves the look a bit. The photos make the track look a bit like a roller coaster, but my track laying isn't quite that bad!

 

pwh1.JPG.0c9eab789a28c1249947b7fd3132044c.JPG

 

Pwh2.JPG.a7800bc5ceeacf9e2c89819760f4b5e3.JPG

pwh5.JPG.9569938f0a8396067420ad182797eebf.JPGPwh6.JPG.c1e62b1833b4a2a01805bcc6ad23d737.JPGPwh7.JPG.da98412edad2a64b0846dccf5cc375cc.JPG

 

I have added a bit of fencing to the vehicle unloading area, and temporarily placed some walling against the backscene - I am not quite sure how to treat the area in the corner by the station building - should have done a bit more planning...

 

pwh4.JPG.8c67963cecca4ea208c8df1517d08166.JPG

 

 

Finally, a couple of shots trying to be arty farty!

 

Pwh7bw.JPG.feda2b8e6c5df03fcfb5fd43d6e84554.JPG

 

pwh3bw.JPG.01aa66bdb5ca2d716af18b93d64951de.JPG

 

 

Edited by Jules
  • Like 12
Link to post
Share on other sites

Thanks - the fire irons do make a difference. I have also added them to my small prairie (on the tank top). They have also benefited from etched brass cabside plates, which look nice when the light catches them!

Link to post
Share on other sites

Hi Jules,

 

Only recently joined RMweb and have just spent a most enjoyable half hour reading your GWR build thread. I must compliment you on a most impressive layout which captures the 'air' of a sleepy GWR Branch Terminus to perfection.

 

I will be following your further progress with great interest as I am just starting to build a 'U' shaped N Gauge GWR layout which will feature a branch terminus on one side. See my blog for further details.

Link to post
Share on other sites

  • 4 weeks later...

Happy New Year fellow modelers!

 

With Hornby releasing a GW horsebox, I thought I would share a couple of snaps of my old Lima one which has had an upgraded chassis.

 

The basic replacement chassis was a heavily modified Dapol loco coal wagon with all the brake gear and under floor gubbins removed leaving just the axle boxes. New brake gear and other bits were added from an etch/detailing kit obtained from mainly trains. Separate handrails and lamp irons were added, as well as roof ventilators.

 

I cannot say it is a true representation of the genuine article, but it looks and runs a lot better than the original.

 

Hope it is of mild interest...

 

post-148-0-77776600-1294052757_thumb.jpg

 

 

post-148-0-05543600-1294052763_thumb.jpg

 

post-148-0-62817100-1294052752_thumb.jpg

  • Like 8
Link to post
Share on other sites

Hi Gareth

 

As requested, some pics of the Slaters van.

 

I made it 25+ years ago, and have no idea what I painted it with! As I was just a penniless teenager (no change in the intervening years!) I probably painted it in whatever paints I had that closely matched the suggested colours.

 

I have just upgraded (as far as tension lock can ever be) from the slaters ones to the small Bachmann type using Finelines pockets, which are really good.

 

Hope the pics are of use/interest

 

Cheers

 

Jules

 

post-148-0-23652800-1294573223_thumb.jpg

 

 

post-148-0-32331100-1294573232_thumb.jpg

 

 

post-148-0-32449600-1294573236_thumb.jpg

  • Like 5
Link to post
Share on other sites

Hi Ian

 

Thanks for the complement smile.gif

 

The backscene is from Gaugemaster. It is actually designed for 'n' gauge, but i thought the 00 would be a bit too 'in your face'.

 

The only trouble is, it doesn't reach the top of the backscene board, so I either need to do some clever paint matching (unlikely!) or buy some more of the same and just use the sky bits. All down to a lack of planning!

 

Cheers

 

J

  • Like 1
Link to post
Share on other sites

  • RMweb Gold

Hi Jules, good to see some updates to Mayshill. The upgraded chassis on the horsebox is interesting - although Hornby are releasing the same diagram, there's nothing quite like doing it yourself, I find.

 

The "N" scale landscape is convincing, that's a useful tip - thanks.

Link to post
Share on other sites

Thanks smile.gif

 

The control panel is now 'mounted' (well, more like wedged) between the top pf the Ikea trestle and a block of wood below it - so it is now mounted vertically. The basic box was from Maplin,

 

I must admit, I am quite pleased with it!

 

The only thing (still) missing from it is the track layout, but as I am the only one to operate it at the moment, that isn't much of an issue!

  • Like 1
Link to post
Share on other sites

  • 2 weeks later...

A small amount of progress has been made......

 

The area around the cattle dock has had a bit of work done : the built up ground has been extended towards the track, covered in grass (needs some variety adding) and a path with fencing added. I'll let the pictures do the talking! (the changes are not huge so you might have to look at earlier piccies to see the difference!!)

 

 

post-148-0-51641200-1295988381_thumb.jpg

 

post-148-0-30420900-1295988376_thumb.jpg

 

post-148-0-58407200-1295988371_thumb.jpg

 

These two are looking to escape!

 

post-148-0-30852400-1295988366_thumb.jpg

 

Whats so special about this one? It is the first of the lineside signs I have added at the end of the platform. Shane the sign itself is out of focus!

 

post-148-0-77909400-1295988361_thumb.jpg

  • Like 8
Link to post
Share on other sites

Jules

 

The track and grass looks good to me (as does the rest of the layout). What have you used for the grass? Regardless of the whether the sign is out of focus the last shot is really good, the sign add nice touch of detail and the farm in the backscene blends really well in.

 

Look forward to seeing further developments!

 

Jon

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...