Jump to content
 

PowerCab problem with thumbwheel


Recommended Posts

4 hours ago, dhjgreen said:

If, as stated by someone on this topic, the holes are plated through, that is a bit risky.  You could remove a connection which goes from one side of the board to the other.  Admittedly the risk is low, but better safe than sorry, use a solder sucker for preference.

The pins go right through, & the holes are flooded with solder. A very low risk indeed I'd say, in this instance.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...