Jump to content
 

ZTC 611 DC mode


richbrummitt

Recommended Posts

Can anyone who has a 611, or upgraded 505/511 know for sure whether the updated/upgraded controller has the facility for DC control (and I don't mean loco 0 ) where you can set individual parameters for different locos that the 511 has?

 

TIA

Richard.

Link to post
Share on other sites

  • RMweb Gold

Can anyone who has a 611, or upgraded 505/511 know for sure whether the updated/upgraded controller has the facility for DC control (and I don't mean loco 0 ) where you can set individual parameters for different locos that the 511 has?

 

TIA

Richard.

 

Yes you can do this.

Page 32 to 36 in the 611 handbook shows you how to do this.

First you need to select the DC output:-

 

POINT-INERTIA-1 OR 2 - ENTER R

 

Where 1 is for pure DC and 2 is for PWM DC

 

You can then set up each loco for different parameters.

There are 2 groups of parameters each group has 4 parameters that you can set for each loco.

 

Group 1:-

 

1.  Start voltage.

2.  Loco Max output voltage(max speed)

3. Inertia

4. Profile(to bend the speed curve of the regulator.

 

Group 2 :-

 

1. Kick Start

2. PWM Frequency (only in PWM mode)

3. Speed scale (to set MPH or Kph max speed displayed)

4. Control mode ( to determine if inertia of profile is used)

 

Up to 50 different loco set ups can be stored.

 

There is a lot more information in the handbook which does go into how to set it all up and alter each parameter.

 

Cheers

 

Ian

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...