juggy0_1 Posted May 27, 2010 Share Posted May 27, 2010 I've just bought a Hornby super detail 8F and i had a new Bachmann 8 pin chip to put into it, now i thought the default address was 3 however it gave no response, i tried a chip from one of my other loco's and it ran fine, tried the new chip in the donor loco but no response !, is the default address something other than 3 for the above chip or is it just plain broke ?. Cheers Link to post Share on other sites More sharing options...
craigwelsh Posted May 28, 2010 Share Posted May 28, 2010 Assume you have a basic system if you can't do a CV readback? Try a factory reset on the chip otherwise unless you have EZ command and can't do that either.. Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.