Farish Blue Pullmann reset for analogue

[Warlingdon]

I have this set which is wired for DCC. I want to change it to analogue operation, but am not sure how. I would be grateful for any advice. Thanks   

[jamesed]

The best way would be to remove the two 6-pin decoders and fit 6-pin blanking plates in their place. Then you can sell the decoders which, if you are lucky might be worth a bit if they are a decent make.

 

You may find that if you put it on a dc track it works providing the previous owner hasn't changed the default cv29 value to prevent dc running. If that's the case, and it doesn't run, then the decoder will need to have a dcc reset or cv29 reprogrammed  (which probably won't be any help if you don't have a dcc controller).

 

However, if you only ever want to run it on dcc then replacing the decoders with blanking plates is the best option and it will run better that way. You can pick up 6 pin blanking plates on ebay fairly cheap or if you know anyone who has a dcc N gauge layout they might have some that they will give you for free.