RSS Fetcher Posted December 2, 2009 Share Posted December 2, 2009 Still waiting for the boiler suited man with spanners so in the meantime challenge work continues at a pace ! For 75p, a strip of balsa split in half gets you a chunky conveyor belt housing in 5 mins.................. Stuck together and cut to a length leaving a few mm either way ready for fitting a quick rummage through the off cuts from the building panels gets you enough to cover 3 sides..................... Finished in 5 mins with the aid of super quick setting Red Rocket and its off to the spray booth along with an equal length of pipe............................. The magic colour as many on here will have discovered in the past is the Halfords Grey car primer. I use the one for plastics.............. Welcome to my sophisticated spray booth with natural vapour extraction !! Dont think SWMBO was too keen on grey kitchen units and worktops !! No problems this time with the paint going wrinkly and half a can later everything was coated to a satisfactory level with any light patches covered later with the weathering. Remebered to mask off the brick work this time ! This stuff doesnt come off to well without lots of scrubbing and very strong thinner ! Once dry I decided to go for an ashphalt roof effect on building 3 and after mixing a pot of 2 & 4mm black & grey ballast I painted the roof area with a layer of pva and sprinkled away ! Left outside for an hour I blew the excess bllast off, checked for any glaring errors and everything is now inside and ready for a test placing on the board and a few more pics. More on that later.......................................... View the full article Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.