Jump to content
 

TCS EUN651 Faulty?


Vonzack

Recommended Posts

Hi,

 

I've recently acquired a Dapol HST bookset fitted with a TCS EUN651 in the Power car and a Bachmann Chip in the Dummy.

 

The dummy end works fine and responds to address 13. The Power car however just runs flat out in reverse when I use DecoderPro to interogate the chip. Actually if you put the loco on the track with any kind of DCC power it just runs backwards. I've checked the chip, pin 1 is in the correct position,so my thoughts are that the chip is blown.

 

Just to add, I swapped the Bachmann decoder from the Dummy to the Power car and it ran fine, so it's definately just something with the TCS EUN651.

 

Any other ideas?

 

Cheers.

Link to post
Share on other sites

Hi,

 

Thanks for the replies.

 

I think the chip has definately had it. I'm using a Sprog II and DecoderPro and whenever you try to read the chip, the loco sets off and DecoderPro returns a 301 error which is no loco found.

 

Cheers.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...