Jump to content
 

Water Tower photo sought


Recommended Posts

I want to model a Sciottish (GNSR) water tower from a 3D printed tank I've had built. I can manage the out flow pipe etc and the stone base but I would like to show the levers and controls that (1) pulled the canvas hose up and (2) opened the valve to allow the water to flow. I've got a number of photos of tanks from below and side but I can't find a photo of an open water tank from above that would show how the latter lever connected to the valve or where the overflow(?) pipe (thing that looks like a flagpole) was situated vis a vis the lever. I know there was no standard set-up, certainly not in pre-grouping days, but any photo at all of the top of an open water tank would be much appreciated

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...