RSS Fetcher Posted December 6, 2013 Share Posted December 6, 2013 The signal box has been modified to overcome the problem mentioned in the previous entry. A 3 mm wide slot was gouged in the underside using a custom made chisel (ground up from a screwdriver). Slots to accommodate the point rods were then cut in the front wall - very carefully, so as not to damage the paint finish applied by Gravy Train. I had been rather apprehensive about hacking at a fully finished model but it proved not as difficult as I'd anticipated. Let's hope that also applied to the forthcoming ballasting! Here's a photo of the box in situ with the rods entering via the new slots. Presumably there would be similar openings for the signal wires, but these have not been attempted. Best not to tempt fate. View the full article Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.