modelman14 Posted February 3, 2014 Share Posted February 3, 2014 Hello all. I`m just wondering if the Bachmann DCC EZ command will give enough power to run an O scale sound equipped Deltic on a 4/5 metre length of track? This is just a temporary measure until I get my N scale Layout finished and then start on a 7mm stabling point/MPD. Thanks in advance for any help! PS I`m new on here so should say HELLO!! Link to post Share on other sites More sharing options...
Andrew P Posted February 3, 2014 Share Posted February 3, 2014 I tried a NONE SOUND O Gauge Heljan 47 and it would only go about 4 ft and then stop and wait for the re set to kick in. But it was fine on my sound fittted Bachmann Brassworks Pannier, and a couple of others with new low current draw Maashima and Cannon motors. In short I would say probably not. Andy Link to post Share on other sites More sharing options...
modelman14 Posted February 3, 2014 Author Share Posted February 3, 2014 I tried a NONE SOUND O Gauge Heljan 47 and it would only go about 4 ft and then stop and wait for the re set to kick in. But it was fine on my sound fittted Bachmann Brassworks Pannier, and a couple of others with new low current draw Maashima and Cannon motors. In short I would say probably not. Andy Cheers for that!! Might have to get a more suitable system sooner then!! Link to post Share on other sites More sharing options...
jcm@gwr Posted February 4, 2014 Share Posted February 4, 2014 Hello Modelman, Welcome to the forum. Jeff Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.