Jump to content

Blog- Snitzl Works - Snitzl : How to make a 30:1 Worm and Gear Wheel.

RSS Fetcher

Recommended Posts

Here's how to make a simple 30:1 worm and gear along with a homemade gear cutter, both lathe and milling machine were used in the process.


Area's of construction lacking detail are covered comprehensively in other blogs or will be covered comprehensively in future blogs


Don't forget, that clicking on any of the images below will give you an enlarged view.

Attached thumbnail(s)
  • blogentry-14904-0-00079600-1413965479_th
  • blogentry-14904-0-37187800-1413965485_th
  • blogentry-14904-0-37281900-1413965493_th
  • blogentry-14904-0-57864300-1413965499_th
  • blogentry-14904-0-65518500-1413965508_th
  • blogentry-14904-0-13620900-1413965515_th
  • blogentry-14904-0-58358000-1413965522_th
  • blogentry-14904-0-92753800-1413965565_th
  • blogentry-14904-0-72503100-1413965573_th


View the full article

Link to post
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...