BIL 'Hazard Lights' In
Today, my DCC Concepts order arrived - so it was time to fit the bodyside indicators.
I have used DCC Concepts MicroLights - these are pre-wired LED's measuring less than 1mm in either direction. I could have used any surface mount LED but the benefit of them being pre-wired is a necessity for me at this size!
I bought a 0.5mm drill to make a hole for the wires to pass through and just stuck the LED on the surface with Loctite.
Not a great photo at the moment - My wife took the photo while I held the wires against my multimeter.
Still en-route is the two speakers, the Howes sound decoder and some NRN Radio pods, I still have to decide on the LEDs used to fit head & tail lights.
I also ordered some 1.6mm 'Butterfly' LEDs which I am planning to use for cab and passenger lights. I'm currently waiting for a new soldering iron before I construct a stripboard 'roof unit' which will contain all resistors for the cab, saloon and BIL lights - when I have this along with the decoder I'll be
able to take some better photos! Then I just need to think about micro plugs to connect the two units.
Does anyone know how I can insert more than one photo into a blog post?
Fred
- 1
0 Comments
Recommended Comments
There are no comments to display.
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now