Leaderboard

I have finally finished the first B set for Cheddar. Little did I know that this was going to be quite so involved when I started, what now seems a very long time ago. The origin was a set of sides, roofs and ends from the Ks kit, kindly given to me by Tim Venton. These coaches were prevalent in the Bristol division after nationalisation so I was always going to have a set on Cheddar. When it came to start, I’d lost one of the ends so ended up making a blank from plasticard. The sides were glued together and married up to a Comet under frame and Bill Bedford sprung bogies. Under frame detail is a mixture of Comet and MJT. The bogie sides were originally the incorrect 9ft pressed steel type before I swapped to the 9ft plate. I also made the mistake of painting carmine and cream before being corrected and advised that this wouldn’t have been applied to non gangway stock. Easily rectified and painted chocolate and cream to match the photos in Russell. Lining is HMRS. Numbering and end lettering is from Railtec. Seating is Ratio, handles Comet and an unmarked bag of unknown origin. Glazing… Hmm. This was individually flush glazed with perspex and yes it did take an age but I’m out of therapy now. I’m never, ever doing this again. Thank goodness for Rapido’s E140/5. I’ve an E129 and E147 to do from Comet kits but at least they’re brass. Whether I’ll ever use the shawplan extreme etching flush glazing on the Airfix b sets remains to be seen. At least they’re pre-cut. These coaches have taken over a year to complete and yes there are plenty of things I could have done better. Apart from some weathering they’ll have to do for now.

There is a photograph in Jim Russell's book 'GWR Wagons Appendix' that shows a wagon loaded with long, thin conifer tree-trunks, of the kind referred to as 'Norway poles'. For some time I have wanted to model a similar load. The wagon itself has been described in this blog before, and has a rather chequered history. Amongst other issues, I put washer plates on the inside, corresponding to the attachment points for the sheet supporter mechanism at each end. I was following the RCH drawing for the sheet supporter parts, which was the only information I had at the time; since then, I have seen photos that show the GWR didn't put washer plates on the inside. I therefore wanted to add a load to hide the washer plates I had put in, so this was my opportunity to model the Norway poles. Making the poles has been a slow process - 15 months in fact. They are made from the twigs of a Christmas tree, with the needles stripped off and most of the bark sanded off. I collected all the suitable twigs from our 2022 tree, but there weren't quite enough, so I had to wait until the 2023 tree became available. Each time, I left the twigs for a couple of months to dry out, then stripped the needles and sanded then with coarse sandpaper. The remaining texture gives a reasonable impression of the partly-stripped bark seen in the prototype photo: The bottom layer of poles was glued to a piece of stiff card about two-thirds the length of the wagon. More poles were glued on top, and the final layer left loose, as I wanted to ensure there was no glue visible. The roping follows that shown in the photo, and is made with 0.75mm rigging thread, as used by ship modellers - the same technique I have described in previous blog entries. A small amount of thin cyanoacrylate glue holds the knots in place. And here with a 2-plank wagon as a runner: Nick.