- Read more...
- 3 comments
- 291 views
thesteambuff
-
Posts
129 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Events
Exhibition Layout Details
Store
Blog Entries posted by thesteambuff
-
Does anyone know the correct sound for the Heljan Garrett on youtube the olivias sounds like 1 engine and the Howes sounds like 2 engines out of sync,which one is correct.
-
Hi
I am constructing a 00 gauge GCR engine shed similar to Leicester and Annesley.
I wondered if anyone have any pictures or diagrams of how the roof over the main section is constructed; I have looked on the net and through all of the GCR books but cannot find anything except a long distance view of leicester shed.
- Read more...
- 3 comments
- 332 views
-
Hi All
I am constructing a steam era engine shed,does anyone know where to get 4 mm blue paving set embossed plastic card.
- Read more...
- 2 comments
- 261 views
-
Hi
I have a loksound 3.5 sound chip for a Bachmann g2,i have tried using a 21pin to 8 pin adaptor but it is to high to fit the tender top back on,there are 4 wires attached to the 8pin plug how can i hard wire these to the 21 pin blanking plate.
Thanks
- Read more...
- 3 comments
- 429 views
-
HI all
Does anyone know of any pictures of the GCR shed roofs at Annesley or Leicester from above.
many thanks
- Read more...
- 3 comments
- 248 views
-
I am building a GCR shed,does anyone know the distance from the front of the shed to the start of the pits inside and outside.
- Read more...
- 1 comment
- 277 views
-
Hi
I have 50 Bachmann /Hornby steam locos to convert to Dcc,i don't know which is the best to go for at a reasonal price,Gaugemaster,Hattons,Bachmann or Lenz.
Any advice would be appreciated.
- Read more...
- 3 comments
- 281 views
-
Hi all,i am modelling a GCR engine shed,does anyone have plans/photos of shear legs to model?
- Read more...
- 3 comments
- 419 views
-
HI Folks
I am wanting to make a work table that slides out from underneath the baseboard,does anyone have plans for one and what type of draw runners are required.
- Read more...
- 1 comment
- 298 views
-
Hi all
Can anyone advise the minimum radius in 00 Gauge for a loop that will run 10 coach/50 wagon trains at realistic express speeds,
thanks
David
- Read more...
- 8 comments
- 499 views
-
I am making an 8 road GCR engine shed,does anyone know how wide this should be,i have read the GCR was more generous with the track centres,i know the LMS was 6ft,52mm centres.
- Read more...
- 0 comments
- 229 views
-
Hi
Does anyone have the plans/dimensions of GCR shearlegs.
- Read more...
- 0 comments
- 280 views