Carnforth

Seconded!

If a rattle can and you have Motor Factors near you that will mix paint, I used RAL 3005 after researching. (As in picking the brains of others )! HTH

Both in the Swindon built lots, maybe all these were green then? 46503/27

At least one did, 46522

Here is a copy of my post from 2009 when the first batch were available. It may or may not help you. Prices and suppliers no longer valid but it gives you an idea. On 25/10/2009 at 10:47, Carnforth said: Mornin. Here should be brief, edited resume of what I did to 2 of these. This applies to the first issue and I posted it on another forum which was active on this topic at the time. Hope it is if some use. Steve I've just re-motored two of these for a friend with Mashima Flat Can 16/28s. ?? 20.50 each inc p+p from CometModels.This gives you as much quality motor as you can get in very easily. The flywheel bores need opening out to 2mm, and there's a small locating pip which needs removing from the chassis casting. The top plastic half of the motor mounting clasp can still be used by careful use of the 4 screws, run only partway in. The other problem which occurs with this model can be tightness of the gear tower assembly. I removed the brass worm and its attendant bearings,note the flats filed on the top edge to stop the bearings from spinning,( there was no end-float between these three parts, and the stub axles were a little too snug in the bearing bores). The inner faces of the bearings were dressed back a little and the bores opened out likewise. Both are now re-assembled and running in lovely. Dead slow crawl at 1v, whereas the motors supplied wouldn't even run with no load at less than 6v and sounded like an angry wasp. Shouldn't be necessary, of course and I' m glad I didn't wait all that time for them to appear with these faults. Poor assembly coupled with an awful motor! That said, it's a nice looking model but runs like a dog, unless you've been VERY lucky. Steve

Of course it did!😀

Yes, I have one if you still need it.

I think Railtec do sheets of rivets, in white rather than black..

Here ya go. Amazon, about £6. Various sizes available but this is 1/8". Discs collect in the sprung retaining cup.

I pinched the wifes, she says Amazon. Examples here.

I dress the axles and nuts back slightly prior to assembly, then use an 1/8" punch on plastic film and sit the disc in the resulting slight rebate, fixed with black acrylic paint. Last job at final assembly.

Any reason why you cannot add wire pick-ups from the live side wheels soldered direct to the frames? Relying on bearings to flow current is fine once running but I wouldn't rely on that alone. HTH

Here's one that I built for one of the service crew of 46441about 35 yrs ago, I did him one in black too. He who pays the piper !!

Betty Beet's Ivatt CL2 46441. Presently resides at L&HR.

They both have different minimum landing sizes, not sure what they are now but for Dabs ( we called them Garves) it is quite small.