Hintez

On 08/11/2019 at 20:34, jcredfer said:

 

That rather depends how long your shaft is - the one attached to the TT Bridge.  I pushed mine fully home, so that there was only a 1/4 inch showing above the collar joining the Bridge shaft to the motor gearbox.  That gives 5 inches from the base of the TT to the end of the motor. The TT Well is another inch, to the top of the baseboard.

 

{I should perhaps mention that when pushing the shaft fully home, there is some sort of a ridge, in the shaft housing, preventing it from going all the way.  I measured the depth with a thinner rod and discovered that the shaft could go further, once past the ridge and that the ridge was quite small.  an application of a 4mm drill dealt with that and I was then able to obtain the maximum contact area between the Bridge axle and the housing, for glueing.}

 

Hope that helps.

 

Regards

Julian

 

Can anybody tell me how much depth it adds below the base of the turntable?