skiddaw Posted November 24, 2013 Share Posted November 24, 2013 I have a Bachmann 2mt 2-6-0 that will not run happily with a DCC chip. It has run previously OK then did some swapping of chips into other locos and ran it on 'normal' dc power with the blanking plate for a while. It now will not run with a chip, I have tried others from other locos with either no response or very intermittent response, It still runs OK on DC. Could this be problem with the circuit board in the tender and if so can the be purchased as spares. The other connections seem OK and the fact that it runs on DC has me completely baffled (though that doesn't usually take much) Thanks in anticipation Neil Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.