RSS Fetcher Posted June 14, 2014 Share Posted June 14, 2014 Hi all! As mentioned in a previous post I replaced my 14 Vac point motor control for 12 Vdc and purchased a new controller to replace the old Piko start kit. This meant that the 14V transformer became available to power the new controller. Since, as can be seen from the enclosed images, the transformer is relatively large and was previously mounted on the baseboard, I decided that I did not want either the transformer or the controller to be permanently attached to the baseboard. So, I installed two sockets under the baseboard for the main track and the programming track I have also installed. This latter can be seen on a shelf alongside the main track. The transformer and controller rest on an auxiliary table. Some tidying-up is still to be done but, at least now, trains can run. Also, space has been left for additional scenic material. Attached thumbnail(s) View the full article Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.