RSS Fetcher Posted June 16, 2014 Share Posted June 16, 2014 Thanks chaps, as no-one offered any kind of therapy following my decision to model the rodding exits from the signal box I found myself ordering cast wire pulleys, 0.11mm stainless wire and another etch of pully wheels etc. Slow progress mainly due to the fact that the pulley castings are not the best and need to be drilled out to allow the wires through - I am getting through a lot of 0.5mm drills with the brass castings ....... I've done a run of 4 wires from the 'box to the foot crossing and yesterday did the run from the 'box to the ground signal next to the camping coach. Right, I'm of to place another order for drill bits with Eileen's ......... Attached thumbnail(s) View the full article Link to post Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.