I've had this one since December last year when I took in part-exchange for a draughtsman's drawing board that I obtained for a bargain price. I had ideas of producing drawings for making patterns for profile-milling but, as it turned out, the board was rather large and the stand was solid cast iron and almost killed me getting it into the back of the van. I knew I didn't have enough room in the house to permanently keep the board indoors and the idea was to keep it in the garage and move in onl
I have done a little more on the bodywork - handrail added but I have used proper brass knobs and .45mm brass wire rather than the oversize plastic knobs and coil of steel wire provided. As predicted, the pipework was destroyed in attempting to remove it from the shrink-wrap, so I have made my own from copper wire, bits of brass tubing and an etched brass wheel. I have also made rims for the spectacles on the weatherboard. The holes in the weatherboard are rather large and my thick plasticard ri
The main frames are ready for the Fitting Shop.
The kit frames are crude, to say the least. The front area of the kit frames consisted of two pieces of cast whitemetal with slots to take the cylinders; a quite ridiculous design, especially when the rest has been made from milled brass. My replacement version is full-length, of course, and has locating holes for seperate cylinders, with slots to locate the motion bracket, all of which will be made from scratch.
I am not going with
The carrier for the crown wheel is done. The wheel is fixed to the carrier by 2-part epoxy glue and the carrier has been drilled and tapped to take a 14BA grub screw, with a flat milled on the axle.The set up has been tested by sticking the two wires onto a controller and it is amazingly smooth.
I have also started to assemble the cylinders, slidebars etc.