Jump to content
 
  • entries
    2
  • comment
    1
  • views
    539

About this blog

Building the APT-Q by making a brand-new APT-S DVT and a potential use for a future APT-S model

Entries in this blog

DVT building process

APT-S DVT - profile testing

before making the entire model, I went to check if the cutaway profile was correct enough to proceed, since I am aiming for it to match current APT-P models on the market.   The idea was to print a small hollowed out section to compare. Here I put a TBF against it to see the profile, and it seems to be slightly taller than what its supposed to be.   Plus, I also realized that the ends of the bottom part of the TBF and the whole bottom section of the NDM is m
BrakeCoach

BrakeCoach in DVT building process

0
×
×
  • Create New...