Sliders
Made a start today on the final board which I have been putting off as it involves a traverser which is something new for me. Have finally settled on using key board shelf runners from Homebase. These are really solid and smooth running due to using ball bearings. First job though was to start hacking them about so they will slide both ways. To do this I cut back the end stop just enough to allow the slider past but not the ball bearing cage. I was not convinced it would work but it does!
Only problem was the dust and swarf from the cutting wheel got into the bearings and made them really crunchy. Soap and water didn't do any good but a cycle in the dishwasher has done the trick!
I also made up a couple of 'L' beams from timber to form the sides of the new board as without a top I think it needs the extra strength. If the weather is OK tomorrow will crack on with this even though I really do have some proper work to do!
1 Comment
Recommended Comments
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now