Managed to get a fair bit done today despite a couple of setbacks - ran out of wood and found big sheet of foam board I had in stock was 3mm not 5mm as is being used for track bed. Both easily sorted but trips to DIY and art store do eat into available time.

Main tracks are now laid and wired on traverser, not sure exactly where the in road will come in so am leaving that for now. Realised that need the other points sorted out before I can lay track on adjacent board so set about that tonight. Getting quite confident with hacking about brand new Peco points now!

With a bit of luck I might just get all the track laying finished tomorrow but then I am going to run into a point motor problem - more on this tomorrow!