Since my last post back in September, I've painted the remaining track and point rodding with basic colours and recently installed the signal wire posts. There's just the rodding outside the signal box to complete and then I'm faced with the slightly daunting task of laying the ballast.

I'll be using C&L ash ballast in the yard and run-round loop and a mixture of ash and proper ballast for the main line. Photos of the real place suggest the ballast even on the running line was pretty old and contaminated with years of accumulated muck, dust and oil. The type and colour of what proper ballast there was is an unresolved question and I'm a bit undecided whether to use a pale grey (granite) or creamy (millstone grit?) colour mixed in with the ash. Any suggestions of the type/colour of ballast in the Lancashire/West Riding border area in the mid 1950's would be welcome.

My proposed method of laying the ballast is to cover an area with loose ballast, then soak in a diluted carpet adhesive with a few drops of washing-up liquid added. A fairly common approach, I think. One concern is whether the glue will also be drawn down the holes in the board for electrical dropper and drip all over the place. Has anyone any experience with this?

Anyway, here are some photos of the current state of play, showing the painted track, rodding and signal wire posts. The tops of the rails have not yet been scraped clean. The dark coloured areas along the back edge and in some sleeper bays are where there will be little or no ballast in the cess and where stretcher bars, point rodding and signal wires pass under the track.

Dave.