I have started a new project.
My cataract surgery was successful. I could start modelling again.

I got some low relief 1:76^th buildings from Petite Properties for my birthday.

So, for my new project I will use them to create a scene for Church Street. One of the kits “No. 2 Station Road” will be used to create a pub.

The kits of Petite Properties are laser cut and look good. “No. 2 Station Road” can also be used for a shop. There is also advice how to finish the building.

For the finishing of the pub I will use texture from several suppliers and some textures I found on the internet.

The pub is situated on the corner of Church Street and Station Road. At the other side of Station Road, opposite to the shops under the arches.

Station Road – shops under arches.

For the pub, I used a name from a Scalescenes kit: The Station.
Here is the start of the building of the pub.

I used the following textures:

Brick texture: Old English Brick from Scalescenes printed on Innova Canvas IFA36

Sign “The Station” from Scalescenes small corner shop printed on mat photo paper from Pro-line 120 gr/m2
Windows and sills from Clever Models printed on 308 gr/m2 Photo Rag from Hahnemühle.
Floor from Smart Models pub kit printed on mat photo paper from Pro-line 120 gr/m2
Entrance texture is from Scalescenes the High Street fronts kit printed on mat photo paper from Pro-line 120 gr/m2

I hope I can show some further progress in a couple of weeks.

Any suggestion or comments are welcome.

Regards,

Job